How to Install Your Speaker Shield

🛠️ Tools & Materials:

Included:

Not Included:

Clean the area around your speaker.
Using a clean cloth and your manufacturer recommended mild cleaner or isopropyl alcohol to remove dust, oils or grime.
Ensure the surface is completely dry before proceeding.
Inspect the surface around the speaker for any damage or irregularities that may affect the shield fit.

Open your Speaker Shield so that you have separated the base from the cover.
Place the base of your Speaker Shield (without removing adhesive backing) over the speaker so it is centered and flush with the surrounding area.
There should be a small space around your speaker between its edge and the base.
Check Orientation - Make sure the locking tab is centered and set at the bottom of the speaker.

Dry-Fit your Speaker Shield (without removing adhesive backing) by holding base to check placement and fit.
Using a pencil trace some interior guidelines for install.
Flip the Speaker Shield over and carefully peel off the backing from the double-sided adhesive tape. Peel slowly to avoid touching the adhesive surface.
Using your guidelines, align your Speaker Shield in place.
Apply firm, even pressure to your Speaker Shield base with your hands for 30–60 seconds. Press around the entire perimeter of the shield base to ensure full contact with the surface.
Attach your Speaker Shield cover to the base.

Dry-Fit your Speaker Shield (without removing adhesive backing) by holding base to check placement and fit.
Using a pencil or marker, mark off each of the screw holes.
Remove base after marking the screw positions.
Drill a pilot hole at each mark using a 3/32" drill bit. Drill straight and to a depth of about ¾" to accommodate the screw length.

⚠️ Be careful not to over-drill or widen holes.

Flip the Speaker Shield over and carefully peel off the backing from the double-sided adhesive tape. Peel slowly to avoid touching the adhesive surface.
Align your Speaker Shield around the speaker, ensuring the mounting holes align with the pilot holes.
Apply firm, even pressure to your Speaker Shield base with your hands for 30–60 seconds. Press around the entire perimeter of the shield base to ensure full contact with the surface.
Using your Drill, insert 1 screw at a time.
- Start with opposite corners to balance tension.
- Do not over-tighten — snug is sufficient to secure the shield without cracking or damaging the surface.
Attach your Speaker Shield cover to the base.

Give your installed Speaker Shield a wipe down with a clean cloth to remove any fingerprints or debris.
Inspect the install to ensure the adhesive is fully bonded / screws are secure and the shield is flush with the surface.
Enjoy the ease of protecting your Audio Equipment. 🔊

Speaker Shield covers are intended for use on flat Fiberglass or Wood surface only.
⚠️ Adhesive is extremely strong — should you need to re-position the base, carefully and slowly peel back from surface. Ensure surface is clean and reapply.
⚠️ Avoid touching or disturbing the shield for at least 1 hour after install to allow adhesive to bond fully.
Use provided stainless steel screws to prevent rust and corrosion, especially in outdoor or humid environments.
Do not install if the area surrounding your speaker is cold, damp, or dusty — ideal surface temperature is 60–85°F (16–29°C).
Over-tightening screws can crack plastic or deform shield frames — tighten by hand if unsure.
Tell your friends & family so that they can protect their Audio Equipment too!